 |
Evotek US, LLC 20 Holstein Road, CA 94960 Tel. 415 460 0919 • Fax: 415 723 9735 E-mail: Store@evotekus.com |
4Lock for Apple iPhone
Tech sheet for 4Lock Car Mount
| How To Use 4Lock iPhone dock for car, truck, bus, and any vehicle with a cabin.
Technical Data • Weight: 120 gr (4.23 oz) • Size: 6.3" X 2.48" X 1.02" (160 X 63 X 26 mm) • Size with whindshield bracket: 6.3" X 2.48" X 5.28" (160 X 63 X 134 mm) • Size with air duct bracket: 6.3" X 2.48" X 3.15" (160 X 63 X 80 mm) • Operating Temperature: -4°F to 176°F (-20°C to 80°C)
Operating Instructions Insert the handlebar bracket prongs (1) into the holes in the back of the 4lock (2) then slide bracket sideways and up, until it locks into place. If using windshield bracket, remove protective film from the suction cup (3) then press suction cup onto the car windscreen. Lower bracket lever (4) to block bracket into place. Position 4lock vertically or horizontally, adjust up/down and left/right inclination by loosening bracket ring nuts (5 and 6), then fasten them back when 4Lock is in the required position. If using air duct bracket, insert flat extremities (7) into air conditioning duct until it snaps safely into place.  Push the short lever of the 4Lock (8) down to release the block and insert iPhone by sliding it into the precision guides of the long lever (9) all the way down. If the Apple power cable has been set in place the iPhone connects and it is ready for being recharged. To remove bracket from windshield, raise lever (4) and lift the suction cup using plastic tab (10).How to extract the iPhone To extract the iPhone, press the short lever of the 4Lock (8) down to release the block, then slide iPhone out of the the precision guides of the long lever (9) using two fingers. How to Set the Apple Power Cable in Place Open 4lock by pressing short lever (8) and insert the USB end of the power cable through the appropriate rectangular hole at the bottom of the long lever (9). Pull the entire length of power cable through until the iPhone connector of the power cable snaps into place.
How to Plug Earphone or Auxiliary Cable in  Inert earphone or auxiliary cable jack into the iPhone. Open 4lock by pressing the short lever (8) to fully release the block, then insert iPhone by sliding it into the precision guides of the long lever (9) all the way down.Technical Support If you have problems with the 4Lock or would like to share comments, please e-mail us at support@evotekus.com WARNING -- Do not attempt to adjust the bracket while in motion. -- Always make sure to see the iPhone is correctly inserted and secured and that the bracket is correctly locked and adjusted. -- Do not tighten the screw bracket too much. Doing so will put the above screw (5) under unnecessary stress. The rubber gasket (6) will keep the bracket safely in place and absorb the stress once the screw it is tightened without applying too much pressure. -- Keep away from fire. -- Do not dismantle, do not tamper with, do not swallow. -- The system may not work correctly if the connector is not plugged in properly. Make sure the connector is plugged in as indicated by the manufacturer. PLEASE NOTE The 4Lock is protected by international patent. Thank you for choosing 4Lock by Evotek Engineering s.r.l. |
