Evotek US, LLC 20 Holstein Road, CA 94960 Tel. 415 460 0919 • Fax: 415 723 9735 E-mail: Store@evotekus.com

4Lock for Apple iPhone
Tech sheet for 4Lock Motorcycle & Bike Mount

How to Use 4Lock iPhone dock for bicycles, motorcycles, and anything with handlebars and any other round bars. What's in the Package • 4lock • Handlebar bracket (0.78" [20 mm] to 0.98" [25 mm]) • Rain protection cover • Instructions Features • Perfect fit for the iPhone • Safe locking in any situation • Power cable housing • Earphones jack housing Technical Data • Weight: 120 gr (4.23 oz) • Size: 6.3" X 2.48" X 1.02" (160 X 63 X 26 mm) • Size with bracket: 6.3" X 2.48" X 3.9" (160 X 63 X 99 mm) • Operating Temperature:  -4°F to 176°F (-20°C to 80°C) Operating Instructions Insert handlebar bracket (1) prongs into the holes in the back of the 4lock (2), then slide bracket sideways and up, until it locks into place. Unscrew bracket (3) completely to open clamp (4), set bracket onto the handlebar then tighten the screw again (3). PLEASE NOTE: Do not tighten the screw bracket too much. Doing so will put the above screw (5) under unnecessary stress. The rubber gasket (6) will keep the bracket safely in place and absorb the stress once the screw it is tightened without applying too much pressure. Loosen bracket ring nut (7) to adjust the angle of the 4Lock as required, then fasten it into place by tightening ring nut (7) again. Push short lever of the 4Lock (8) down to release the block and insert iPhone by sliding it into the precision guides of the long lever (9) all the way down. If the Apple power cable has been set in place, the iPhone connects and is ready to be recharged. How to extract the iPhone To extract the iPhone, press the short lever of the 4Lock (8) down to release the block, then slide iPhone out of the the precision guides of the long lever (9) using two fingers. How to Set the Apple Power Cable in Place Open 4lock by pressing short lever (8) and insert the USB end of the power cable through the appropriate rectangular hole at the bottom of the long lever (9). Pull the entire length of power cable through until the iPhone connector of the power cable snaps into place. How to Plug Earphone or Auxiliary Cable in Inert earphone or auxiliary cable jack into the iPhone. Open 4lock by pressing the short lever (8) to fully release the block, then insert iPhone by sliding it into the precision guides of the long lever (9) all the way down. Technical Support If you have problems with the 4Lock or would like to share comments, please e-mail us at support@evotekus.com WARNING -- Do not attempt to adjust the bracket while in motion. -- Always make sure to see the iPhone is correctly inserted and secured and that the bracket is correctly locked and adjusted. -- Do not tighten the screw bracket too much. Doing so will put the above screw (5) under unnecessary stress. The rubber gasket (6) will keep the bracket safely in place and absorb the stress once the screw it is tightened without applying too much pressure. -- Keep away from fire. -- Do not dismantle, do not tamper with, do not swallow. -- The system may not work correctly if the connector is not plugged in properly. Make sure the connector is plugged in as indicated by the manufacturer. PLEASE NOTE The 4Lock is protected by international patent. Thank you for choosing 4Lock by Evotek Engineering s.r.l.